Setting up a new blade for a band saw is sometimes a hard job. But there could be help with Arduino power.
I needed a small amp so I decided to repurpose an old car stereo that had been collecting dust in the basement.
Made a bench PSU from scratch using the ZK-4KX DC-DC Buck Boost module and a 3D-printed body.
This project walks through how to install the 2026.1 version of the AMD FPGA tool suite on an Ubuntu host PC.
To me, an important part of building 18650 Lithium Ion power banks is recycling good pre-loved cells. How do you know which ones a good?
Ever wanted to build custom battery packs for, solar power banks but found commercial spot welders too expensive? I've got the best solution
This tool will be certainly very useful when you need to make precise and stable connections to small points of a printed circuit board.
A tiny function generator built using the ATtiny1614 microprocessor and its internal Digital-To-Analog Convertor (DAC).
Create and connect to a Jupyter Notebook server on your Raspberry Pi to control your MATRIX Voice or MATRIX Creator!
M5Stack Multi-Tool has Distances measurement, Spirit level, Voltage sensor, Find my phone, Torch, Home automation controls
The best aid for powering your Arduino or Raspberry Pi projects.
Go t the PSU and decided it also needed a DC Inlet for Battery Power
This project walks through how to setup the Vivado & Vitis projects for debugging using integrated logic analyzers in HDL in verison 2023.2.
WIND is a project accelerator for the Adafruit Feather series microcontrollers. It turns them into easy to mount and wire together projects.
A device for controlled ejection of fluid by volume (medicine/ chemical / fuel) or drop by drop for different applications.
This project evaluates the low cost ZK-PP2K High Power PWM & Pulse Signal Generator module
A small hand-held tachometer that uses a laser to show how fast an object is rotating in revolutions per minute (rpm).
A clip-on electronic depth gauge for a Dremel Drill Press. No wires or screws required.
Raspberry Pi Docker Box - Start and Stop containers with a button
Made a Fume Extractor by using a custom Attiny13 Based Motor driver board and 3D Printed Body,
A tutorial to develop Max7219 8x8 Dot Matrix via "skiiiD."
A tutorial on using an SG90 servo motor with "skiiiD."
Tutorial to use Joystick_HW504 module with "skiiiD."
An implementation of Nikodem Bartnik's 3D printed dremel CNC with a 500W spindle and a PocketBeagle. Created for ENGI 301 @Rice Uni.
