It is hard to measure the height of the children. So, we made Height Measure using distance sensor VL53L0X.
I was able to modify Adafruit's Freq Show program to enable it to run on the pocket CHIP.
I made a tool to program the Arduino Pro Mini without the need to solder pins to attach the USB bus port.
Create and connect to a Jupyter Notebook server on your Raspberry Pi to control your MATRIX Voice or MATRIX Creator!
Sorry - this is not a hardware project, by maybe it helps you as much as it does to me and lets you edit a config. txt file with more fun...
WIND is a project accelerator for the Adafruit Feather series microcontrollers. It turns them into easy to mount and wire together projects.
Solderless Breadboard Prototyping requires firm connections to ensure low resistance: Pin headers can facilitate the unusual.
With just a few minutes make a simple oscilloscope good for measuring frequency, testing capacitors and much more.
Soldering needs to be done in a well-ventilated environment or a Fume Extractor should be used.
A circuit for writers and bloggers that prints words or sentence on press so you don't have to type keywords in document multiple times.
I have a little paint booth in my shop, so I created a device to shake paint cans for me.
A device for controlled ejection of fluid by volume (medicine/ chemical / fuel) or drop by drop for different applications.
The Particle Web IDE, Particle Dev, and Particle-cli are not the only ways to program Particle devices.
The revival of an old favorite screw gun thanks to 3D printing and some electronic assembling.
I needed a small amp so I decided to repurpose an old car stereo that had been collecting dust in the basement.
Here I built a simple digital voltmeter circuit with a PCB using ICL7107.
Rebuilding the PIC Inductance meter on STM32F030.
Tutorial to use Gyro Sensor MPU6050 module with "skiiiD"
My daughter loves to make woolen pompoms. But this is a strenuous thing and often consumes all our nerves. High time for a technical update.
Do you live in constant fear of your robot being stranded as it gets you Taco Bell all because it’s motor became disconnected? Fear no more!
skiiiD Editor is IDE for development boards. Now, it supports Arduino Uno and Mega with 70+ modules.
Dual-pulse battery tab spot welder using repurposed and rewound microwave oven transformer and solid-state relay.
This tool will be certainly very useful when you need to make precise and stable connections to small points of a printed circuit board.
A tutorial to develop Max7219 8x8 Dot Matrix via "skiiiD."