A Linux handheld gaming device built in 4 weeks using the phyFLEX-AM62Px SOM, KiCad hardware, and open-source software.
Low power doorbell triggered by PIR sensor, without power on camera 24x7.
We will interface the MPU-6050 module with Odinub to read gyroscope and accelerometer value and print them.
In this project we are going to tell you about how to print custom character in 16 * 2 LCD using 8051 microcontroller.
Nowadays the temperature is rising due to global warming, and we gotta keep track of it. This small application does it for you.
Empower your STM32 development journey with our comprehensive tutorial on getting started with the STM32 Black Pill and STM Cube IDE.
This tutorial will show you how to connect the MPU6050 to the Seeed Studio RP2040 development board. This is a step-by-step guide.
This project walks through how to develop software applications to run on the MicroBlaze processor in an SP701 using Vitis Unified 2023.2.
A joystick controlled pen capable of simple drawings with a MSP432 at its base. Final project for Applications of Embedded Systems.
Tria provides pre-verified designs for its platforms. This project describes how to re-generate the Vivado 2023.2 designs from source.
In this build, we use Toit to easily create a temperature controlled fan for my overheated bedroom.
Ada controls the SensorTile and supports the BlueMS SoC on the tile to allow sensor data to be sent over BLE connections.
It's a tutorial but with freeform circuitry components.
Made a super small Buck converter module based around LM317 that can provide a stable 5V for powering XYZ electronics.
Ready to Drive system is a circuit used in Formula Student Competitions which is responsible for safe starting operation of the Vehicle.
Log sensor values such as temperature, humidity, air quality to a Notion page. The project uses Raspberry Pi running balena with SensorHat
A reference example of protocol conversion between up to 2Mbps UART and Ethernet with WIZnet WIZ145SR which consists of STM32F103 and W5300
A nanoFramework + RAKwireless RAK811 module based LoRaWAN client. Tested on The Things Network (TTN) the Spark NZ networks.
In this project I'm showing you how to build a much better, still cheap and easy, filtration system
Hive monitoring using sensors and LoraWan network.
An ESP32-S3 companion robot featuring FreeRTOS, motion sensing, audio playback, games, and a custom 3D-printed enclosure.
This project describes how to add support for Vitis-AI 3.5 to the Tria Vitis Platforms.
Raspberry Pi PICO 2 Powered TEMP GUN based around the GY-906 Infrared Temp Module.
Build a fully integrated, wireless, high-power BLDC motor driver using TMC6200 and ESP32S3 that you can use to actuate just about anything.
