The amplifier described in this project is "Hybrid", but now the case is reversed and the Tube is used at the output.
A 2x260W@4Ohm audio amplifier complete with a preamp and some basic digital controls/monitoring
In this project, we have designed a touch sensor that powers LED when the test point terminals are touched with a finger.
For the MCU BoosterPack Design Challenge
We have a new project using the tone control circuit.
This project was made to monitor the level of any liquid that have water.
Tone control is a type of equalization used to make specific pitches or "frequencies" in an audio signal softer or louder.
An Electret Microphone Preamplifier that is a condenser mic along with a single transistor amplifier.
Here is the story behind homemade amplifier.
Presented here is the Guitar Amplifier. The best part of this project is that it is recycled and portable.
I made this transistor based stereo preamplifier board to control the volume, bass and treble of my previous build TDA2030 amplifier.
The simplest way to make a relatively powerful stereo Vacuum Tube audio amplifier with components that are easily available.
I got my hands on low cost SMT assembly service offered by JLCPCB. Get the best quote in very low price just on JLCPCB starting from $8.
In This Project We Will Tech You, How To Make A Simple Bass Booster Circuit At Home Easily. You Can Make This Circuit At Very Low Cost
let's build a USB to TTL converter
A mini amplifier - can be used in cars, home theaters and in small stereo systems. Hi-Fi TDA7377 operated on a single power supply unit.
Do not look at if you are making few wats toy.
This ECC83 (12AX7) preamplifier project successfully delivers the warm, pleasant, and dynamic sound characteristic of vacuum tubes.
A 200w HiFi mono amplifier with signal gain boosting options. This is TDA7294 class AB ic. Let's boost the power with TDA
I added the warm sound of crackle and Pop to my silent gas fireplace using an Arduino nano, mp3 decoder and an amplifier.
I designed this amplifier using TPA3116d2 ic and PCB is fully assembled by JLCPCB SMT assembly service. let's see the performance of this.
Now it is time to get start with my own designs of class D amplifiers. This is the base article to getting started with 2.1 Audio amplifier
I got my hands on one of the best car Class D amplifiers, and this is my review on these units.
Learn how to amplify and control the volume of the sound from the BBC micro:bit through the Speaker of Snap Circuits.
