A Pico 2 checks a 4-wire cable 100 times a second and latches any fault, so a wire that only fails when you wiggle it gets caught.
10 test patterns, moving box, SMPTE bars and a image overlay, in plain Verilog. Output: AXI4-Stream, FVAL/LVAL
Test transistors, diodes, thyristors, resistors, capacitors and inductors. Also identify their leads and obtain their component value.
This Arduino-powered Web Oscilloscope supports trigger, and changing voltage/div, offset and time / div. It supports 6 channels.
A small logic probe for CMOS and TTL circuits. Measures 5 states, detects pulses and can play different tones for the different states.
A simple self contained Scalar Network Analyzer. It is used for testing and alignment of RF circuits, including amplifiers and filters.
Test up to 12 servos with features such as setting movement range, velocity or acceleration, playback a sequence of positions & more
Design, development, and validate a low-cost, open-source (OS) water testing platform which costs less than commercially available tools.
A simple circuit with minimal components which allows you to test the Nrf24l01 modules, range and other parameters. Just for testing purpose
Make a dummy load for a lower voltage DC power supply. Very good if to test a power supply you got or if you are trying to make one.
A compact 2-in-1 device that tests electronic components and charges your mobile—perfect for makers, students, and DIY repair
A tiny function generator built using the ATtiny1614 microprocessor and its internal Digital-To-Analog Convertor (DAC).
It's a simple, handy device for testing Nixie tubes and Nixie tube drivers.
This project compares inferencing MobileNet and EfficientNet-Lite on the Coral dev board vs MaaXBoard and Raspberry Pi.
Many times we need from the FPGA some signals for use it as stimulus for other circuits. This board brings us 4 analog outputs for Ultra96.
Ever wish you could use BNC cables or probes with the XMEGA Xprotolab?
Automatic tap tester based on a Particle Photon, relay shield, lift magnet, boring socket for stylus fixture and Paperino ePaper display.
Diagnose the type and integrity of USB and RJ45 cables with this Touchscreen Cable Tracer. Appearances can be misleading with cables!!
See how to script a series of test measurements for automated testing on the ADP3450.
This device will test and heal all Nixie tubes you know.
Design, develop and validate an open source water testing platform to perform Nitrate Reductase Nitrate-Nitrogen Analysis Method.
HIL devices are excellent for real-time simulations of electronic circuits - in this project I show you how you can create your own!
Introducing my DIY function generator project: a compact, low-cost waveform generator built around the versatile LM324 quad op-amp IC.
This project walks through how to use the logic analyzer function in Digilent's WaveForms software to prove in a custom bit bang interface.
