Turn a XIAO ESP32-S3 into a USB to I2C bridge with Bit Pirate, then read an LPS22 by register name in your browser. No code.
Monitor and control a reverse osmosis system for your reef or house water purification.
Glowing LED to detect the increase in pressure by pressure pad using Arduino.
Ever wake up in the morning found your CPAP mask is off? This device will alarm you if you have unintentionally removed mask during sleep.
An Arduino-based altimeter, mostly for model rocketry.
An air quality (particulate matter) and environmental (T/H/P) sensor system built with a Raspberry Pi Zero W, Python & Redis.
CPS120 is a high quality and low cost capacitive absolute pressure sensor with fully compensated output.
Analyze foot traffic across a wide range of environments by embedding pressure sensors in flooring or rugs. Helium makes it portable!
Air Quality, Radar, and more on one board, the ultimate start for your smart home - Let's see how to integrate this into Home Assistant!
Now we can check out the depth of the sea level by using a pressure sensor (MS5803–01 BA) connected to an Arduino, and display sensor data.
Real-time temperature monitoring, location tracking, and alert system implemented using LoRaWAN devices on Helium Network.
A low budget acquisition system for low budget sensors.
Dive into lake water monitoring with the help of CAN communication.
How much negative pressure does a cooker hood create? An attempt to measure the pressure drop with a simple environmental sensor.
DIY Rocket not only for fun but learning about barometric pressure with the help of Arduino IDE & Infineon's KIT_DPS368_2GO.
Monitor stretch forces using Adafruit's conductive rubber cord and a NodeMCU ESP8266. We'll encode the output to a JSON string.
A simple, low-cost flex and pressure sensor!
A beginner project utilising an Arduino and a BME280 sensor capable of giving you 4 environmental readings.
AKA how to build your own laboratory vortexer without spending a lot of money.
Temperature, humidity, lux, pressure. Create LoRa node under 30 minutes. No wiring, no coding. With Ubidots you add graphs and widgets.
A lowcost multi-pressure, multi-speed massager with timer for Joint and muscular pain,
Get the highest accuracy and efficiency when measuring altitude with BMP180 Pressure Sensors by using a tilt sensor and a vibration motor.
Using the XIAO ESP32C6, I connect an atmospheric pressure sensor via Zigbee, sending real-time data to Home Assistant for monitoring ☁️.
Model rockets are a blast - SMRT lets you extend those seconds of excitement by capturing your flight data in real time, for later analysis!
