Build regional Meshtastic InkHUD maps for Taiwan, with layered zoom levels that fit the Wireless Paper flash budget.
A headless predictive maintenance node using LoRa and BLE for remote diagnostics.
We propose a optimized TinyML classifier on-device to continuously analyze vibration patterns and detect mechanical faults at the edge
How to get temperature sensor data from a remote Raspberry Pi via Wireless LoRa Protocol.
A simple add-on for mobile phones to enable SMS-like messaging in a group when outside cell coverage, or in disaster scenarios.
This project takes you through all the steps required to get your RAK831 LoRa Gateway module up and running with WiFi as the backhaul.
Small, cheap, low-powered sensors are still a challenge to make. LoRa-Tooth uses $6 BLE modules to make untethered sensors with long range.
Here is how to make a single channel LoRa Gateway compatible with The Things Network using standard components you can buy everywhere.
Here's how to connect your phone to a LoRa module using standard components you can buy everywhere, along with an example chat program.
Introducing the next iteration of the Ripple LoRa QWERTY Messenger project, now with ultra low power standby mode!
This tutorial describes how to create your own LoRa GPS tracker using Wio Terminal. The Sender 's location on the map can be seen live.
A device that combines real-time location tracking and two-way pager, over a LoRa mesh network.
DIY LoRaWAN gateway with support The Thing Networks and Helium.
An end-to-end beehive monitoring solution enabled by the Helium Network and deep learning.
A solar-powered, outdoor air quality monitor that transmits data over LoRaWAN networks like The Things Network and Helium
Express your love as a RAKstar
Introducing the next iteration of the Ripple LoRa QWERTY Messenger project, now with GPS support!
M5Stack recently released an updated LoRaWAN module. This tutorial teaches you how to connect it to The Things Network using UIFlow.
How to build a LoRa Gateway with the n-fuse mPCIe card, an Orange Pi or Raspberry Pi, and connect to the Things Network.
How to build an ultra low power LoRaWAN / The Things Network device using a MaxBotix ultrasonic sensor.
LoRa GPS Tracker using Grove LoRa-E5 and the possibility of real-time tracking on the map, No need to install the app on the phone.
Display device data with style by integrating The Things Network and WolkAbout IoT Platform.
NPK Sensor, PH, EC, Moisture, Temperature Sensor RS485 Modbus
The best project to use automation for long range without internet and GSM. Try the LoRa transmitter and receiver project to turn ON/OFF.
