Simplified version of Ben Eater's breadboard clock with chip count reduced from 6 to 3. I use this clock with my 6502 and Z80 projects.
A base station for future builds.
Have you ever needed a specific resistor/capacitor that you don't have? You can probably make that value using components you already have!
This a simple Humidity Checker from ground-up within few minutes of using the Breadware's prototype hardware without any prior knowledge.
In this video, the main focus is to make a system which will give a notification as and when there is change in temperature.
This project monitors every breadboard hole without probing using the M5Stack, supporting circuit verification and education.
An IOT device that measures the humidity and temperature of its surroundings
Whether the sun light will be there or not you will know it earlier so that you can have correct monitoring of your plants and can care for
The system works by setting up a scenario on the Integromat service which activates the buzzer connected to your bolt device
This project showcases a TIMI-96 module controlled by an Arduino Uno to output readings from a set of potentiometers.
It is easy to set up the power supply for the bread-board with a USB PD. The output voltage is from 3.3V to 20V.
You'll learn how to create and assembly your own Arduino Tiny Laboratory.
STM32 black pill and STM cube IDE to blink external connected LED using HAL programming.
I’ll show you how to turn a VL53L0X time-of-flight sensor and RP2350 screen into a distance detection tool. Sci-fi is here.
Simultaneous 5V and 3.3V output, filtered and protected.
In this project we will learn how to blink an LED on stm 32 using bread board.
With STM32 black pill and STM cube IDE to implement a sequence where three LEDs blink in various combinations.
With the utilization of particle argons and sensors, we have constructed a reversing vehicular tool!
This smart shop controller is for any shop concerned with safety, security and sanitation. A fully connected device for any shop owner.
A low-cost ESP32 IoT system that monitors poultry water temperature in real time on a 20,000-bird farm, sending alerts and reducing producti
This device measures the rotational speed of fans and records the difference of temperatures due to variating speeds said fans.
This is a demo of the Particle Photon 2 and the Hiletgo ILI9341 TFT. The end result is a nice, clean dice rolling app.
Quickly explore a variety of op amp configurations on a small PCB with solderless component headers, supply rails and a signal generator.
If your phone, watch, house, and lights can be online, why can't your tape measure? The ADTS provides a wifi enabled measurement system.
