Learn how to build efficient motor control systems with STM32 microcontroller
How to convert from analog to digital signals and vice versa using simple Python on microcontrollers.
Receiving and sending the digital and analog signal through AD5669 interface with Arduino to detect the A/D pulses.
How to Use a Digital to Analog Converter Aptinex DA4C010BI
Make that industrial sensor remotely accessible without writing a single line of code.
This PVIM Board is a Precision, Eight Channel, Synchronous Data Acquisition board (DVM), with Simultaneously Sampled Isolated Inputs.
Monitor your heart precisely with this DIY electrocardiograph
In this project, the GreenPAK™ IC is used in the design of a carbon monoxide detector.
Learn how to interface the MCP3008 8-channel 10-bit ADC with an STM32 microcontroller using the SPI serial interface
Playing with different resolutions and showing the results on an old analog oscilloscope.
This project will allow you to display a battery level and current date and time on the OLED expansion.
In this project, we will make a function generator using the gen4-uLCD-43DCT-CLB display module.
This program demonstrates the use of reading an ADC Channel value and displaying it on an I2C 7-Segment Display
Discover precision with STM32 ADC & ACS712 Hall Effect-Based Current Sensor. Optimize current measurement for accurate power monitoring
When diagnosing industrial equipment and conducting scientific research, there are always problems of data collection.
This project continues with the bare metal application in Vitis for using the Digitizer Zmod on the Eclypse Z7 in a custom design.
Created a basic oscilloscope using 2 ADC in interleaved mode up to 24 msps, or dual channel Oscilloscope. Also support X/Y mode.
CMOS IC THA offers a settling error lower than 0.5% and minimizes dynamic power consumption to 10uW with a high gain and phase margin
Tutorial on how to use Xilinx Zynq-7000 XADC. Part 2 of 3 explains how to do the HW design in AMD Xilinx Vivado.
A basic breakout for the ADG732 32 channel multiplexer and video tutorial!
For the MCU BoosterPack Design Challenge
I made an audio amplifier using a simple op-amp circuit that will be read using the STM-32 Nucleo.
Maybe I add the note latter. This project is about how to something to be digital.
The pH Level Monitor project uses 4D Systems' gen4-uLCD-50DT to display the pH level of a certain substance.
