Birthday Surprise with LED Using BOLT IoT

Take the circuit connections as below:

Connect the led pin in which negative leg is connected to GND pin and positive led is connected to one end of resistor.The other end of resistor is placed in one of the GPIO pin(here I connected to 0 pin).

Here you need to first create an account on Integromat by using the link below:

https://www.integromat.com/en

1.Create a newScenario in integromat

2. Add BoltIot as your module and click continue( Incase if you skip this step you can add your modules in the next step)

3. Click on the question mark symbol and add boltiot as your module.

4. Click on Boltiot and click on executecommand..

5. Click on add beside connection and you get a new tab and enter the API key linked to your bolt cloud.

6. Enter the API key and click ok and then enter the boltiot tab and enter writedigitaloutput in the command section, enter device name as boltdevice linked in your bolt cloud.(you can get this on https://cloud.boltiot.com) and enter the GPIO pin as what you have connected the resistor in the circuit(here I connected to 0)

7. Add tools (sleep) since you want it for only certain period of time.(Here I select for 9 seconds and it is optional).

8. Add another module by clicking addmodule of tools button.

9. Again consider the bolt module and fill as asual as the first bolt module you have done(Here you need to change the state as LOW).

10. Click on the clock button on the first bolt module and then set run scenario as specified dates(Since birthday is a specified one we select the birthday through the specified month and days and also the time).

11. Save the scenario and in case if you want to test it click on RunOnce.

Circuit Connections:

Youcanconnectmanyledlikethistothecircuitandalsoyouneedtochangethecodeinthe Integromat.(SinceIhaveonlyoneIdidnotdoithere)

Project video link:

https://youtu.be/ZdjOxyiOtFc

CODE:

There is no code required to run this.