Nuand Launches Revised BladeRF 2.0 SDR with a Host of New Improvements

Back in 2013, San Francisco-based Nuand debuted the original bladeRF SDR (Software Defined Radio) module — a $400 board that went beyond…

Cabe Atwell
2 years ago

Back in 2013, San Francisco-based Nuand debuted the original bladeRF SDR (Software Defined Radio) module — a $400 board that went beyond what a USB TV dongle could achieve and allowed you to communicate over a broad spectrum of frequencies.

Five years later, Nuand has announced a revision of the favorite board with the new bladeRF 2.0, which comes in two versions — the bladeRF 2.0 micro xA4 and bladeRF 2.0 micro xA9, both offering the same 47MHz to 6GHz frequency range, and 61.44MHz sampling rate, with the latter outfitted with Intel’s 301KLE Cyclone V FPGA.

Both versions of the blade RF 2.0 are backward compatible with the original, meaning they can use the same software that was written for the original. As far as hardware is concerned, the xA4 ($480) sports Intel’s Cyclone V FPGA with 49kLE, 2X2 MIMO with 61.44MHz sampling rate, 56MHz filtered bandwidth, automatic gain control, as well as automatic IQ and DC offset correction.

The xA4 is also equipped with 128-tap digital FIR filtering, USB 3.0 SuperSpeed support via a Cypress FX3 peripheral controller (with an integrated 200 MHz ARM926EJ-S processor), factory calibrated SiTime MEMS VCTCXO, and a 32-pin I/O header.

The more expensive ($720) xA9 uses most of the same hardware and feature set as the xA4, except it’s outfitted with the more powerful Intel Cyclone FPGA with 301kLE, which houses a larger amount of logic gates for increased signal processing.

In terms of software, each board can take advantage of Windows, Linux, and Mac OS X-based PCs, as well as other third party programs, like GNU Radio, Pothos, MATLAB, and more. Both versions are now available along with a few accessories, including cases and power amplifiers.

Related articles
Sponsored articles
Related articles