|Hand tools and fabrication machines:|
Maybe you don't have an additional monitor or display to connect to your DragonBoard to program and make changes in settings using Debian graphic interface. It is easier for beginners to see what they are doing and send commands in prompt.
In this tutorial, you will see how to install and run VNC to control your DragonBoard remotely.
Install and configure port and dimensions of the session
$ sudo apt-get install vncv4server $ vncserver :1 $ vncserver -geometry 800x600
If you want to end to session:
$ vncserver -kill :1
You need to install VNC on host computer to access DragonBoard, go to the link below, download and install it.
After installation, get IP address of the board typing:
In this case,
Open VNC viewer in Host Computer and type
192.168.0.218:1 on VNC server address. Now you are able to configure and access your board remotely.
Did you replicate this project? Share it!I made one
Love this project? Think it could be improved? Tell us what you think!