433 MHz with Remote!

#include <RCSwitch.h>
RCSwitch mySwitch = RCSwitch();
int LED = 11;

void setup() {
  Serial.begin(9600);
  mySwitch.enableReceive(0);  // Receiver on interrupt 0 => that is pin #2
  pinMode(LED, OUTPUT);
  digitalWrite(LED, HIGH);
}

void loop() {
  
  if (mySwitch.available()) {
    
    int value = mySwitch.getReceivedValue();
    
    if (value == 0) {
      Serial.print("Unknown encoding");
    } else {
   
     Serial.print("Received ");
      Serial.print( mySwitch.getReceivedValue() );
      Serial.print(" / ");
      Serial.print( mySwitch.getReceivedBitlength() );
      Serial.print("bit ");
      Serial.print("Protocol: ");
      Serial.println( mySwitch.getReceivedProtocol() );
    }

    if (mySwitch.getReceivedValue() == 4152588) {
       digitalWrite(LED, HIGH);
      }
    if (mySwitch.getReceivedValue() == 4152624) {
      digitalWrite(LED, LOW);
      }
    if (mySwitch.getReceivedValue() == 15954498) {
      digitalWrite(LED, LOW);
      delay(1000);
      digitalWrite(LED, HIGH);
      }

      
    mySwitch.resetAvailable();
    
  }

}