All about it
This shield is an Arduino shield for freetronics OLED Display. http://www.freetronics.com/products/128x128-pixel-oled-module#.UkJUBZB-_IU It contains a proto area, two connecters for OLED – 1.Direct Connection and 2.Cable Connection, status LEDs (SDCD and PWR) and a reset button. Created 25/09/13 ©Jed Hodson 2013.
The all important parts
You can order the PCB from OSH Park (http://oshpark.com/) Link to PCB - http://oshpark.com/shared_projects/5Dyth6rT,(If link not working just look for the title 'OLED Shield'. The OLED from Freetronics http://www.freetronics.com/products/128x128-pixel-oled-module#.UkJUBZB-_IU and then all it requires is 2x 5mm LEDs, Straight Headers and a push button.
Design files
The Files can be downloaded Github
https://github.com/jedhodson/FreetronicsOLEDArduinoShield/
Example of this in project
See this example http://www.hackster.io/jedhodson/temperature-humidity-and-time-date-on-oled
UPDATE - R2
The rev. 2 of this board includes:
Larger Proto Area
Right Angle mostly eliminated
16/10/13
Rev. 2
Notes
Just a few notes:
1. Price of PCB from OSH Park is $25.10USD (According to OSH Park)
2. I do NOT accept responsibility for damaged hardware when using this device
3. Please contact me if you wish to mass produce this design (email [email protected] or comment.)
4. OPEN SOURCE HARDWARE ENJOY !!!
Photos R1
Construction
When constructing this board start with the resistors followed by the LED (Do NOT install the SDCD LED as it does not work. Error with OLED) and reset button. Then install the 2x5female header in the on board OLED and then the 2x5 male headers. Now install the arduino headers. Plug in the Arduino and OLED and away you go.
Design
Comments