Digital Clock Using 8051 with 7 Segment Display

As we are showing proteus simulation so FOR CODING AND SIMULATION YOU REQUIRE:

1. Keil uvision: There are lots of product from keil. You will require c51 compiler. You can download that software from here.

2. Proteus Software for simulation: This is the software to show simulation. You will get a lot of information to download this software.

If you are doing it in hardware, then you would require one software that is flash magic to upload the code in your hardware. Remember flash magic is developed by NXP. You cannot upload all 8051 family microcontroller through this software. So you can only upload for Philips based controllers.

Components Used:

Here in our demo video we are using proteus simulation but definitely if you are doing it in your hardware, you will require these components for this project:

• 8051 Development board: So if you have this board it will be better so that you can easily upload the code by yourself.

• Seven Segment Display: In this project we are using six Common Anode Display.

• USB to UART converter: This is 9 Pin D type male Connector For RS232 O/p

• Some Jumper Wires

Circuit Diagram:

Code and Video:

The whole project description is given in above video.

You can get the source code from our GitHub Link.

If you have any questions regarding this project, feel free to comment below. And if you want to learn more about embedded system you can visit our YouTube channel.

Please visit and like our Facebook page for frequent updates.

Thanks & regards,

Embedotronics Technologies