circuito.io team
Published © GPL3+

Red Balloon Carbon Monoxide Detector

Worried about the quality of air around you? This project will help you monitor the air pollution levels in your surroundings!

BeginnerFull instructions provided2 hours11,464

Things used in this project

Hardware components

Arduino UNO
Arduino UNO
×1
RGB Diffused Common Anode
RGB Diffused Common Anode
×1
Resistor 220 ohm
Resistor 220 ohm
×1
Breadboard (generic)
Breadboard (generic)
×1
Resistor 10k ohm
Resistor 10k ohm
×1
Resistor 100 ohm
Resistor 100 ohm
×2
Male/Male Jumper Wires
×1
4xAA battery holder
4xAA battery holder
×1
Male/Female Jumper Wires
Male/Female Jumper Wires
×1
SparkFun Carbon Monoxide Sensor - MQ-7
×1
USB-A to B Cable
USB-A to B Cable
×1
SparkFun Gas Sensor Breakout
×1

Software apps and online services

Arduino IDE
Arduino IDE
circuito.io
circuito.io
Use this link to go directly to the selected components on circuito.io - https://www.circuito.io/app?components=10820,11021,12083,9403

Hand tools and fabrication machines

helium charger

Story

Read more

Schematics

Red Balloon Schematics

Code

Red Balloon Carbon Monoxide Detector

Replace the test code firmware.ino tab you got in the circuito.io reply with the Red-Balloon-Air-Pollution-Detector.ino in the link below. Make sure to keep the libraries and define the pins correctly

Credits

circuito.io team

circuito.io team

29 projects • 596 followers
Circuito.io is an online platform that generates wiring and code for Arduino projects. Want to know more? Visit http://circuito.io

Comments