Panda1409
Published © GPL3+

Light Show

Make four LEDs light up in order.

BeginnerFull instructions provided2,020
Light Show

Things used in this project

Hardware components

Arduino UNO Wifi Rev.2
Arduino UNO Wifi Rev.2
×1
Breadboard (generic)
Breadboard (generic)
×1
Resistor 330 ohm
Resistor 330 ohm
×4
LED (generic)
LED (generic)
×4
Jumper wires (generic)
Jumper wires (generic)
×5

Story

Read more

Schematics

screenshot_2019-07-23_at_11_ddLdkufe4V.png

Code

Untitled file

Arduino
resistor 1	3-a	last negative in the first block left side		
resistor 2	8-a	last negative in the second block left side		
resistor 3	13-a	last negative in the third block left side		
resistor 4	18-a	last negative in the fourth block left side		
LED 1	positive 3-c	negative 2-c		
LED 2	positive 6-c	negative 7-c		
LED 3	positive 11-c	negative 12-c		
LED 4	positve16-c	negative 17-c		
red wire	2-e	13 on board		
yellow wire	6-e	12 on board		
white wire	11-e	-11 on board		
green wire	16-e	-10 on board		
black wire	last negative on in the last block left side			GND on  board

Credits

Panda1409
0 projects • 0 followers

Comments