Published March 8, 2021

Arduino Watering System

Another intresting project to consider is the Arduino Watering System. Everyone has at least one plant in their room, kitchen or balcony. Is

IntermediateFull instructions provided2 hours1,589

Things used in this project

Hardware components

water pump

SparkFun Soil Moisture Sensor (with Screw Terminals)

Arduino UNO

Jumper wires (generic)

MAKERFACTORY 5V relay module compatible with Arduino

Story

The soil moisture sensor value goes from 0 to 1023, when the sensor recive a value minor than 600, the relay turn on and the pump starts to irrigating the soil. To adapt the 220V home tension, I used a phone charger. Open it, remove the USB connector, find the VCC and GND pins (probably 1° and 4°) and connect it to the Arduino pins (like the wiring diagram)