Magnetic Wiha Screwdriver Holder

Here's a useful fixture if you want to mount a Wiha screwdriver set (this one, available on Amazon) to a ferromagnetic surface. In my case, this was a milling machine, but there are obviously other applications as well.

Step 1: Materials

• 3D Printer - I used this one (Amazon)
• Disk Magnets (Amazon)
• Filament - Marble (Amazon)
• Plasti-Dip
• Masking tape

Step 2: Print Spray and Mark

Print based on STL found here. Mask off the sides of the holder, then spray the back with Plasti-Dip so it doesn't slide around on your surface.

Fill in recessed "+" and "-" symbols with a marker as desired.

Step 3: Add Magnets and Use

Magnets will simply snap into place, and it's ready for attachment to a metal surface and your drivers!

Note that Amazon links are affiliate.