CJA3D
Published © LGPL

Holiday Wreath Automation

Automate your holiday wreath using an Arduino MKR1000, NeoPixels, and a buzzer. Get notified via SMS/email when someone is at the door.

BeginnerFull instructions provided5 hours2,570

Things used in this project

Hardware components

Arduino MKR1000
Arduino MKR1000
×1
NeoPixel strip
NeoPixel strip
×1
Buzzer
Buzzer
×1
Breadboard (generic)
Breadboard (generic)
×1
Jumper wires (generic)
Jumper wires (generic)
×1
Li-Ion Battery 1000mAh
Li-Ion Battery 1000mAh
Lithium Ion Polymer Battery - 3.7v 1200mAh
×1
PIR Motion Sensor (generic)
PIR Motion Sensor (generic)
×1

Software apps and online services

Arduino IDE
Arduino IDE
Maker service
IFTTT Maker service

Hand tools and fabrication machines

3D Printer (generic)
3D Printer (generic)
Soldering iron (generic)
Soldering iron (generic)

Story

Read more

Custom parts and enclosures

Arduino MKR1000 ,Breadboard and lipo holder

Arduino MKR1000 and Breadboard holder, you will have to cut one end of the +ve and GND rail of the breadboard.

Holder closure plate

Plate that closes and snaps fit at the top of the case.

PIR sensor holder Base

PIR sensor holder Lid

Schematics

Circuit

Connect the NeoPixel to pin #6 of the Arduino MKR1000
Connect the Piezo buzzer to pin #5

And if you plan on going with the advance setup
Use the PIR sensor connected to pin #2

Code

Github

Credits

CJA3D

CJA3D

10 projects • 80 followers
Tinkerer and 3D Printing enthusiast.

Comments